Skip to main content
Westpac Presto Smart (VX 690)

Navigating your Westpac Presto Smart (VX 690)

Kevin avatar
Written by Kevin
Updated over a week ago

In this article

How to enable Westpac Pay At Table

Supported on Abacus POS 2.8.100 and later.

You can have 1 Westpac Pay@Table terminal per POS, which can be either the Master or Slave. Every terminal must connect to its own POS.

When your Westpac payment terminal and Abacus POS are connected to each other, toggle on Pay At Table on the top right corner of the Simple Payments Integration page. Your Westpac terminal will then say Pay At Table.

With Pay At Table enabled, a waiter will be able to select which table they would like to initiate payment for, using just their payment terminal without the POS.

How to enter standalone mode (3G backup)

If you lose your main internet connection and you need to make card payments, you will need to use your Westpac card reader in standalone mode.

  1. On the card reader, press ENTER + 3

  2. Select 1) Unpair terminal

  3. Select Yes. The screen will display "Unpairing terminal".

  4. You will be asked to unpair from the POS. Select Yes. The screen will display "Unpairing terminal".

  5. When the unpairing has been completed, the screen will display "Terminal unpaired".

  6. The screen will then display "Pair with POS". This means your Presto Smart VX 690 is now in standalone mode.

How to disable Bluetooth on the Presto Smart

1. Enter standalone mode by pressing Enter + 1 simultaneously

2. Enter the Merchant Password

3. Scroll down and press "Utility" then "Bluetooth Config"

4. Press "Remove Pairing" and press "X" to exit out of the standalone screen and return to integrated mode

Did this answer your question?